INSTALLATION PROCEDURE:

VISIONTEK GSM Integrated Payphone package consists of the following.
• GSM Integrated payphone – 1 No.
• Antenna – 1 No.
• Power Adaptor – 1 No.
• User Manual – 1 No.

INSTALLATION:

Installation Procedure:

Proper Connect the Antenna to the SMA connector (Or Antenna Socket)
Connect the Charger to DC Socket.
On the Switch which is on the base of the Idea CCB.

Step 1) Initializing

(In Initializing the CCB Unit must read all the data in CCB.)

Step 2) Net Searching

(In Net Searching the CCB Unit finds the Idea Network.)

Step 3)
(After the finding Network the Unit is on and Display Shows)

IDEA !!!
WELCOME

Now the Unit is ready for used.
(Before Using the unit set your Local Area Code)


Note: After Installation Charge the Battery Min 9 Hrs for Full Charge


Instructions Chart:
Instructions chart should be pasted nearer to the GSM CCB installation place.

The following points to be noted while installing the GSM CCB:

1. The GSM CCB should be installed on a flat surface.
2. If it is wall mounted it has to be mounted properly.
3. The GSM CCB should be protected from sunlight and rain.
4. Initial training should be given to the customer regarding do’s and don’ts.

SIM Card Installation:

The GSM Integrated payphone requires a SIM (Subscriber Identification Module) for its normal operation. SIM socket is provided on the Mother board.

1. Disconnect power supply if it is already connected to the power socket.
2. Open GSM Integrated payphone front door with help of key.
3. Open the SIM card holder.
4. Ensure for proper direction of the SIM card and insert it gently into the SIM card holder.
5. Close the SIM card holder and press the SIM card holder in forward direction for locking.
6. Close GSM Integrated payphone front door with help of key.

NOTE:
1. SIM installed in the GSM Integrated payphone gets locked to the unit and only Airtel GID Group cards will work.
2. The GSM Integrated payphone will work with only Airtel SIM cards.



Antenna Installation:

1. Antenna connector is provided at the right side of the unit.
2. Connect the antenna supplied with the unit to the connector and ensure for proper contact.
3. After antenna installation fix the protection clamp which is provided along with the unit.





Power Connection:

1. Plug in the primary of adaptor into 230V AC power socket and the secondary to the Power socket (DC 7.5 V 1 A) provided at the Right side of the unit.
2. Every power on and power off condition need to enter date and time.
3. Switch ON the unit and observe for the following LED indications on the front panel.
1. Red LED indicates the presence of AC power.
2. Green LED indicates the presence of Network. LED Blinking indicates the availability of network.

Check the working status:
Lift the handset and hear for the dial tone.

1. The operator message.


NOTE:• For recharging the SIM dial the IVRS number
• Signal bar indication provided on console display.
Receiving Calls:
1. The telephone will give a ring on receiving the incoming call.
2. Calling party number is displayed on the LCD display **.
3. Pick up the handset to answer the call.
** Subject to network support